Instructional Guide:

How to Check and Change the Carbon Brushes on Your Stryker Autopsy Saw

This guide provides a step-by-step walkthrough to help you safely inspect and replace the carbon brushes on your Stryker 810 or Mopec 810 autopsy saw.

Whether you are performing routine maintenance or troubleshooting power issues, inspecting your carbon brushes regularly is critical for tool longevity, smooth operation, and operator safety.

Quick Overview:

• Required Tools: Flathead screwdriver (straight-slot)

• Estimated Time: 5–10 minutes

• Maintenance Frequency: Check every 6 months or whenever you notice a loss of power/excessive sparking.

⚠️ Safety Disclaimer: Always ensure the saw is completely unplugged from the electrical outlet before opening brush caps or performing any maintenance.

Pro-Tips Before You Start:

• Inspect Wear: Replace carbon brushes if they are worn down to less than 1/4″ (6 mm) in length or show chipped edges.

• Maintain Orientation: If you are inspecting and reinstalling the same brushes, make sure to insert them facing the exact direction they were removed to match the commutator wear pattern.

• Replace in Pairs: Always replace both carbon brushes at the same time for balanced motor performance.